Name: Polaris 600 RUSH 2010
Brand: Polaris
Rating: 4 (1 reviews)

To Next Page

To Previous Page

9.34

Chassis

10. Reinstall the lower steering shaft nut. Torque nut to

specification.

11. Reinstall the tie rod boot.

12. Reinstall the bulkhead floor plate.

13. Reinstall the left fender assembly using new rivets.

14. Reinstall the following components:

• Right/left engine compartment door

•Hood

• Exhaust pipe/silencer

• Oil tank/clutch cover assembly

• Airbox assembly

• Engine assembly

• Left side front suspension components

NOTE: Allow the adhesive to cure for 24 hours at 68°

(20° C) before placing the snowmobile back into

service.

Right Bulkhead Clip Removal

1. Remove the following components:

• Right/left engine compartment door

•Hood

• Nosepan/bumper

• Exhaust pipe/silencer

• Exhaust silencer bracket

• Oil tank/clutch cover assembly

• Airbox assembly

• Engine assembly

• Bulkhead floor plate

• Right side front suspension components

• Fuel tank (Remove fuel hoses and gasoline from

nk)

2. Drill out the rivets securing the right fender to the

bulkhead and

chassis.

3. Remove the exhaust silencer bracket.

4. Remove the two remaining brace screws and nuts.

= T

Steering Shaft Nut: 22 ft-lbs (30 Nm)

Questions and Answers:

Need help?

Do you have a question about the Polaris 600 RUSH 2010 and is the answer not in the manual?

Polaris 600 RUSH 2010 Specifications

General