Polaris 600 RUSH 2010 User Manual

8.35
Steering and Suspensions
8
NOTE: Apply Polaris Premium Grease to pivot
shafts. Verify pivot shaft mounting faces are free
from grease.
3. Install components in reverse order of disassembly.
Use new loc
k nuts where applicable. Torque
fasteners to specifications.
NOTE: On adjustable camber models inspect and
re
-adjust camber settings after replacing the control
arms or spindle rod ends.
Spherical Bearing Replacement
1. Remove the lower control arm from the vehicle.
2. Place the control arm on th
e bench and remove the
retaining ring.
3. Using an arbor press, press the spherical bearing out
o
f the bore.
4. Obtain new spherical bearing. Use an arbor press and
p
ress the bearing into the control arm bore. Press on
the outer bearing race.
5. Install a new retaining ring with the flat (sharp) edge
ou
t.
= T
Control Arm-to-Bulkhead Nuts: 30 ft-lbs (41 Nm)
Front Control Arm-to-Bulkhead Fastener/Nut:
40 ft-lbs (54 Nm)
Control Arm-to-Spindle Fasteners: 40 ft-lbs (54 Nm)
Sway Bar Linkage Fastener: 15-22 ft-lbs (20 - 30 Nm)
NO GREASE

Polaris 600 RUSH 2010 Specifications

General

Horsepower	120 HP
Engine Displacement	599 cc
Cylinders	2
Cooling	Liquid
Bore x Stroke	77.25 mm x 64 mm
Fuel System	Cleanfire Injection
Ignition	Digital CDI
Front Suspension	PRO-RIDE
Rear Suspension	PRO-RIDE
Track Width	15 in
Track Lug Height	1.25 in
Front Travel	9 in
Ski Stance	42.5 in
Brake	Hydraulic Disc
Width	48 in
Starter	Electric
Drive Clutch	P-85
Track Length	121 in
Rear Travel	14 in
Ski Type	Gripper
Driven Clutch	TEAM