Polaris 600 RUSH 2010 User Manual

9.38
Chassis
8. Reinstall the over structure-to-bulkhead screws.
Torque screws to specification.
9. Reinstall the cross shaft fastener. Torque to
spec
ification.
10. Reinstall the idler arm bolt and nut. Torque nut to
s
pecification.
11. Reinstall the tie rod boot.
12. Reinstall the bulkhead floor plate.
13. Reinstall the right fender assembly using new rivets.
14. Reinstall the following components:
• Right/left engine compartment door
•Hood
• Exhaust pipe/silencer
• Oil tank/clutch cover assembly
• Airbox assembly
• Engine assembly
• Right side front suspension components
NOTE: Allow the adhesive to cure for 24 hours at 68°
F (
20° C) before placing the snowmobile back into
service.
= T
Over Structure-to-Bulkhead Fasteners:
22 ft-lbs (30 Nm)
= T
Cross Shaft Fasteners: 35 ft-lbs (47 Nm)
= T
Idler Arm Nut: 37 ft-lbs (50 Nm)

Polaris 600 RUSH 2010 Specifications

General

Horsepower	120 HP
Engine Displacement	599 cc
Cylinders	2
Cooling	Liquid
Bore x Stroke	77.25 mm x 64 mm
Fuel System	Cleanfire Injection
Ignition	Digital CDI
Front Suspension	PRO-RIDE
Rear Suspension	PRO-RIDE
Track Width	15 in
Track Lug Height	1.25 in
Front Travel	9 in
Ski Stance	42.5 in
Brake	Hydraulic Disc
Width	48 in
Starter	Electric
Drive Clutch	P-85
Track Length	121 in
Rear Travel	14 in
Ski Type	Gripper
Driven Clutch	TEAM