2
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
2.41
HANDLEBAR ANGLE ADJUSTMENT
Handlebar angle can be adjusted to suit rider preference.
Factory settings are shown.
1. Loosen the four bolts on the handlebar block.
2. Adjust the handlebar upward or downward to the
desired angle. Be sure the handlebar, brake lever and
throttle lever operate smoothly and do not hit the gas
tank, windshield or any other part of the machine
when turned fully to the left or right. If necessary,
loosen the set screws for the left and right controls,
rotate the controls slightly, then tighten the set screws
to the proper torque.
IMPORTANT
Do not stretch wires while adjusting the controls.
Stretching the wires could damage the hand warmers.
3. Tighten the bolts to specification.
TORQUE
Handlebar Mount Bolts:
7 ft-lbs (9.5 Nm)
MAINTENANCE
To Next Page
Loading...
