5.4
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
FUEL TYPE SELECTION – STANDARD
GAUGE
Use the following procedure to change the fuel type
designation in the gauge. Refer to the fuel type selection
label located inside the left side panel.
1. Start the engine.
2. Press and hold the center
button to enter the
Options Menu.
3. Press and release the MODE button until FUEL TYPE
is displayed in the information display area.
4. Press and release the SET button to toggle through
available options until the desired fuel type is
displayed in the information display area.
5. To exit Options Menu, Press and release the MODE
button until EXIT appears in the information display
area.
6. Press and release the SET button to exit. The fuel
type being displayed is the active fuel type.
FUEL TYPE SELECTION – INTERACTIVE
DIGITAL DISPLAY (IDD) GAUGE
IMPORTANT
Always verify ETHANOL (ETH / E-10) is selected on
the instrument cluster if you are unsure of the fuel type.
Severe engine damage may occur if NON–ETHANOL
mode is selected when using ethanol-blended fuel.
Never use fuels containing more than a 10% ethanol
blend.
NOTICE
The factory fuel type setting is set for ETHANOL fuel.
1. Turn the ignition key to ON (RUN) position or start the
engine.
2. Use the gauge key pad to configure the settings on
the gauge.
3. On the IDD, select the MAIN MENU.
4. Select VEHICLE SETTINGS.
5. Select FUEL TYPE.
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
