Polaris 850 SKS 155 2020

3
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
3.151
EXHAUST REMOVAL
1. Remove the side panels and hood.
2. Using a commercially available spring removal /
installation tool, remove the exhaust springs
q
connecting the resonator and the tuned pipe.
3. Remove the exhaust spring
w
connecting the front of
the resonator to the chassis.
4. Remove the exhaust spring
e
connecting the rear of
the resonator to the chassis.
5. Cut the routing clip
r
and cable tie
t
the secure the
EGT sensor to the main harness.
6. Disconnect the EGT sensor
y
.
7. Carefully separate the resonator and tuned pipe and
lift upward to remove the resonator from the chassis.
8. Remove the exhaust spring
u
connecting the tuned
pipe to the chassis.
ENGINE / COOLING / EXHAUST