Polaris 850 SKS 155 2020

8.34
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
REAR SUSPENSION SERVICE
BOGIE WHEEL SERVICE
REMOVAL
1. Remove the two fasteners
q
, spring lock washers
w
,
and washers
e
securing the suspension to the
chassis. Allow the rear suspension to drop below the
chassis.
2. Remove the spacer
r
, spring washer
t
, and bogie
wheel
y
.
BEARING REPLACEMENT
1. Remove the snap ring
q
from the bogie wheel.
CAUTION
Wear eye protection when removing the snap ring.
2. Press the bearing
w
out of the bogie wheel.
3. Install a new bearing into the bogie wheel by pressing
on the bearings outer race.
4. Install the snap ring.
IMPORTANT
Ensure the snap ring is fully seated.
INSTALLATION
1. Install the bogie wheel
y
, spring washer
t
, and
spacer
r
.
STEERING / SUSPENSIONS