108
Slide Scanner Repair Manual Diagnostics and Troubleshooting
It should be checked with:
• SCSI ID set to 8 (Keeps video signal turned on - SS35 PLUS only)
Note: The SCSI ID setting is not relevant to SS35/SS35 ES to keep video signal turned
on. If video signal turns off for SS35/SS35 ES, cycle power off and then on to
regain video signal.
• Transporter in its home (calibration) position
Also check the video output signal (Figure 5-1) with the home (calibration) position blocked.
If the video output signal indicates any irregularities, follow the steps in the flow diagrams shown in
Figures 5-2 and 5-3 to correct the calibration failure.
To Next Page
Loading...