81
Slide Scanner Repair Manual Parts Replacement
Installation
1. Install the chassis assembly.
2. Install and tighten the three (3) screws that secures the chassis assembly to the bottom case.
3. Reconnect the transporter spring.
4. Install the main controller PC board.
5. If applicable, check the alignment of the filter wheel assembly as explained in Section 3 of
this Repair Manual.
Note: For original SS35 and SS35 ES up to serial no. B6xxxxxxD.
6. Check the focus/magnification adjustments as explained in Section 3 of this Repair Manual.
7. Install the top housing.
To Next Page
Loading...