14
Slide Scanner Repair Manual Scanner Overview
Features
Table 1-2 list and describes the features of the slide scanners (Figure 1-2).
Table 1-2. Slide Scanner Features
Feature Description
Power LED Indicator This green LED indicator lights to indicate when the
slide scanner power is turned on.
Note: During power-up the slide scanner initiates its
self-test mode.
Ready LED Indicator This yellow LED indicator lights to indicate when the
slide scanner is ready to operate (passed power up
self-test).
Notes: • This indicator continually blinks while the
slide scanner cycles through its self-test.
• Upon completion, this indicator lights steady
to indicate that the slide scanner is ready to
operate.
Top Access Slot The top access slot is used when scanning 35 mm slide
transparencies.
Side Access Slot The side access slot is used when scanning unmounted
slides and 35 mm filmstrips using the filmstrip carrier
included in the accessory kit.
Filmstrip Carrier Included with the accessory kit.
Used to scan a 35 mm negative strip or an unmounted
slide. Supports 35 mm filmstrips from 1 - 6 frames.
Release Button This button is used to release the front cover when
replacing the lamp. (Spare lamp located inside front
cover.)
Power On/Off (1/0) Switch This switch turns the slide scanner power on or off. The
green Power LED lights to indicate that the slide scanner
is turned on.
To Next Page
Loading...
Need help?
General
