EGM-5 Operation Manual V. 1.04 9 support@ppsystems.com
Powering up the EGM-5 for the First Time
When you receive your new EGM-5 from PP Systems you will need to first connect it up to the external
power supply/charger prior to powering up the instrument. To avoid accidental power up during shipment
we put the instrument into “Ship Mode” (see Ship Mode on page 53). Therefore, when you are ready to
begin:
1. Locate the power supply/charger and power cord inside the packing box.
2. Connect the AC power cord to the mains and the barrel connector into the EXT Power socket on
the back of the EGM-5.
3. Press the ON/OFF switch to power up the instrument. The power switch should now have an
illuminating blue ring indicating power is on.
4. Allow 10-15 minutes to achieve warm-up.
You are ready to go!
Data Storage
For convenience and ease it is very important to note that all EGM-5 system data is recorded and saved
directly to a USB flash drive (i.e. memory stick or thumb drive). A USB flash drive is included in the spares
kit (Part No. 43034-1) with every new system.
THEREFORE IT IS IMPERATIVE THAT YOU HAVE A USB FLASH DRIVE WITH YOU AT ALL TIMES
IF YOU WANT TO RECORD DATA WITH YOUR EGM-5. OTHERWISE DATA WILL HAVE TO BE
RECORDED MANUALLY.
To Next Page
Loading...
Need help?
General
