PP Systems EGM-5 User Manual

EGM-5 Operation Manual V. 1.04 106 support@ppsystems.com
Get/Set Parameter Values Table
Get/Set Parameter Values
Number
(X)
Parameter
Name
Description
Valid Values
Default Value
1
Zero Type
See
Zero Settings on page 34.
The values are: 1=Automatic,
2=User Set, 3=Manual
1-3
1
2
Zero Time (min)
See
Zero Settings on page 34.
1-40
20
3
Average Limit
(ppm)
See Averaging Settings on page
43.
0-100
30
4
Alarm Low (ppm)
See Alarms Settings on page 37.
0-100000
250
5
Alarm High (ppm)
See Alarms Settings on page 37
0-100000
2000
6
Alarm Sound
See Alarm Sound on page 39.
0=Off; 1=On
1
7
CO
2
Concentration
(ppm)
See Analog Voltage Output on
page 22.
100-100000
2500
8
EGM ID
See EGM ID on page 44.
0-9
1
9
Pump Power (%)
Percentage of the pump power
(i.e., air flow).
0-100
60
10
Host Measure
Format
See Host Measure Settings on
page 46 for more information.
1-6
3
11
Host Measure
Interval (seconds)
See Host Measure Settings on
page 46 for more information. Use
‘0’ for manual mode to stop
broadcast.
0-3600
1
12
Memory Measure
Format
See Memory Measure Settings on
page 48.
1-6
3
13
Memory Measure
Interval (seconds)
See Memory Measure Settings on
page 48.
0-3600
1
14
WIFI Measure
Format
See WiFi Measure Settings on
page 48.
1-8
8
15
WIFI Measure
Interval (seconds)
See WiFi Measure Settings on
page 48.
0-3600
0
16
Display Measure
Format
See Memory Measure Settings on
page 48. Note: Interval is always 1
second.
5,6
5
17
CRC
Determines whether a CRC-8 will
be appended to each command
sent from the EGM-5.
0=Off; 1=On
0
18
Web Monitor
Adds terminator to strings sent to
the WiFi Port to use for web pages
0=Off; 1=On
1
19*
Host Serial
Selects which Serial Host input to
use: USB or WiFi
0=USB
1= WiFi
0

PP Systems EGM-5 Specifications

General

Brand	PP Systems
Model	EGM-5
Category	Measuring Instruments
Language	English