Precor Precision 400 Series - Page 69

Return To Service
15. Reinstall the stairarms, see "Stairarm Assembly Replacement" on page163.
16. Plug
1
in the power cord and switch the power “ON"
17. Start a manual workout and operate the machine from min to max resistance and
incline at low and high spm. Verify that the belts operate correctly, no slipping or
unusual noises.
18. Reinstall all removed covers, see "Covers and Panels Replacement" on page75.
19. Verify operation and return to service, see ("Operation Verification" on page19).
1
Device power cord connector or electrical cable male connector that is inserted into an
electrical receptacle "outlet" (also called the plug-in).
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 61
5 Adjustment Procedures
Input Drive and Step-up Belt Tension Adjustment