Verify hardware validation diagnostic tests
Perform the equipment Hardware Validation Tests (see "Standard Service Menus" on
page36) to help isolate the cause of the issue. These tests will help identify failed system
components. Resolve any resulting failures.
Verify that there are no new error codes
After correcting the issue, reopen the Error Log (see "Error Log Display" on the next page)
and verify that there are no remaining active error codes. This will verify that the original
error codes are not reoccurring and that there are no new error code issues. If the error
code is reoccurring, the issue may be mileage related, review the error code odometer his-
tory to verify if the error event is related to mileage intervals.
Note:If there is no logged error codes and the issue persists, you will need to use
observable and audible indicators to identify the source of the failure. Also make
sure that there are no related service bulletins that may resolve the issue. Browse
the list of available Troubleshooting procedures for related Troubleshooting
information.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 215
7 Troubleshooting
Basic Troubleshooting Steps
To Next Page
Loading...
Need help?
General
