MY SETTINGS DESCRIPTION
Default: 60 min
SET MAX
WORKOUT TIME
Sets the maximum workout sesstion time.
Range: 1 - 90 min
Default: 90 min
NOTE:A setting of 90 min allows unlimited workout session time.
SET MAX SPEED Sets the equipment maximum workout speed.
Range: 0.5 - 12 mph (0.8 - 19.3 kph)
Default: 12 mph (19.3 kph)
SET MAX PAUSE
TIME
Sets how long the equipment remains in a paused workout ban-
ner state (the time waiting for the user to continue the paused
workout) before exiting the workout and resetting to the default
Welcome state.
Range: none, 30 sec - 5 min
Default 30 sec.
DEMO Mode (R40)
DEMO Mode
(R40 consoles only)
DEMO mode is used to demonstrate the R40 console Workout program screens. DEMO
mode continuously cycles through each Workout program until DEMO mode is exited.
IMPORTANT: DEMO mode locks out “disables” all motion controls and menu
softkeys and may make you think the console is not working properly. Make sure
that the console is not in DEMO mode: go to service access DEMO mode (code
5555) > select “Turn Demo OFF” > Save.
Enter DEMO mode:
How to enter service software access DEMO mode:
1. From the console default Home page select the Settings softkey.
2. Simultaneously press and release the My Settings (upper right) and Edit (lower
right) softkeys.
Note:The My Settings (upper right) and Edit (lower right) softkeys might be blank
"OFF" however they remain active softkeys. Simultaneously press and release the
upper and lower right side softkeys to access the System Settings page.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 34
4 Standard Service Menus
DEMO Mode (R40)
To Next Page
Loading...
Need help?
General
