SERVICE VIDEOS.
1. Wipe down equipment using a soft lint-free cloth using only the recommended clean-
ing solution. Always spray cleaning solution directly onto the cleaning cloth and not
directly onto the equipment surface to avoid equipment damage due to excessive
moisture.
CAUTION: Do not use acidic cleaners and do not spray directly onto the equipment
surfaces.
2. Rinse surfaces using a clean lint-free cloth dampened with water only.
3. Then completely dry with another clean lint-free cloth.
Power Requirements
Equipment Power Requirements
The equipment input power from the wall outlet receptacle must be a good quality and
stable power signal (not fluctuating or intermittent) to insure the best performance and
trouble free operation.
Power Specification
l
120 VAC 60 Hz models
o
Operating voltage: 90 VAC to 132 VAC.
o
AC frequency range: 47 - 65 Hz
o
15 amp individual branch circuit
l
240 VAC 60 Hz models
o
Rated operating voltage range: 180 VAC - 264 VAC.
o
Frequency: 47- 65 Hz
o
15 amp individual branch circuit
Frame Grounding Requirement
For operator safety and to minimize electrostatic discharge conditions have a certified elec-
trician verify that the AC frame ground continuity to be a low resistance connection to the AC
distribution ground bar
CAUTION:To avoid electrostatic discharge shock, make sure that there is AC
frame ground continuity.
Individual branch circuit requirement
(US and Canada installations)
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 16
2 General Information
Power Requirements
To Next Page
Loading...
Need help?
General
