Precor Precision 400 Series - Tools and Supplies

Tools and Supplies
Tools and supplies required to complete the machine service and repair.
Tools
• US and Metric Hex Key set • Standard straight slot tip screw drive set
• US and Metric socket set • Philips tip screw driver set
• Us and Metric wrench set • US & metric Allen wrench set
• Cutters • 7/16” Allen key, socket mounted
• Rubber mallet • Pliers
• Tape measure /Straight edge ruler • Inner and outer snap ring pliers
• DVM
1
meter • Torque
2
Wrenches: 9 in lbs to 100 in - lbs
(83 ft-lbs)
1
digital volt meter
2
Torque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut
example: 5 NM torque is equivalent to 5 newton's of force applied one meter from the center
of the bolt, 6 ft-lb is equivalent to 6 lbs of force applied 1 foot away from the center of the
bolt.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 10
2 General Information
Tools and Supplies