INFORMATION DISPLAY DESCRIPTION
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
U-BOOT SW The console upper boot software version information.
U-BASE SW The console upper base software version information.
USAGE LOG Shows workout usage information for each individual
workout including the number of times and the total accu-
mulated time the workout was used.
Error Log List of the equipment stored error event codes (stores a
maximum of 30 error codes).
My Settings Menu (5671)
Service Access Code: 5671 (see "R20 How To Access Standard Service menus" on
page28)
The My Settings service menu is used to customize the equipment user interface loc-
alization and Workouts default settings.
To learn about the R20 console My Settings service menu, refer to the TRM425 Owners
Manual:
l
Owners Manual.
MY SETTINGS DESCRIPTION
SAFETY CODE Enabled or disabled. When enabled, a user password (xxxx) is
required to use the machine.
Factory default: disabled
SET UNITS Sets units of measure to US Standard or Metric.
Default: U.S.
SET DEFAULT
WORKOUT TIME
Controls whether workouts start with a default session time that is
different from the maximum session time.
Default: ON, 30 minutes
Range: 1 to 90 min
Use State: ON or OFF
If ON use must set a Default workout time in minutes.
Range: 1 to 240 min, NO LIMIT
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 33
4 Standard Service Menus
My Settings Menu (5671)
To Next Page
Loading...
Need help?
General
