Printronix P5000 - Page 40

40
Chapter 3 Troubleshooting Display Messages
23.5V CTL FAIL*
23.5 Volt Controller Failed: a
voltage failure on the
controller board.
1. Cycle Power. Run the print job
again. If the message appears,
download the emulation software
again (page 150).
2. Cycle power. Run the print job
again. If the message appears,
replace the flash memory.
3. Power on the printer. Run the
print job again. If the message
appears, replace the controller
board. Record the message and
return it with defective board.
4. Power on the printer. Run the
print job again. If the message
appears, replace the power
supply board.
5. Power on the printer. If the
message appears, replace the
shuttle frame assembly.
31 PAPER OUT
TIMEOUT
In the CT emulation with a
coax interface, a time-out
message is sent to the host
if paper is not loaded within
10 minutes after CLEAR
was pressed to clear a paper
out fault.
1. Load paper. Run a print test. If
the message appears, replace
the paper detector switch
assembly.
2. Run a print test. If the message
appears, replace the controller
board. Record the message and
return it with defective board.
Table 2. Message List
Message Explanation Solution