List Of Messages
41
32 PAPER JAM
TIMEOUT
In the CT emulation with a
coax interface, a time-out
message is sent to the host
if paper motion has not
occurred for 10 minutes after
CLEAR was pressed to
clear a paper jam fault.
1. Clear the paper jam. Press
CLEAR.
2. Press PAPER ADVANCE
several times and check that
forms feed without erratic motion,
noise, or pin-hole damage. If
forms do not feed, go to Paper
feeds poorly, page 106. If forms
feed, go to step 3.
3. Press VIEW once and check that
forms move up. Make sure the
forms thickness lever is not set
too tightly.
4. Press VIEW again and check that
the forms thickness lever rotates
and the paper moves down. If the
forms thickness lever does not
rotate and/or the paper does not
move down, refer to Reverse
paper feed: platen does not
open, page 108.
5. Check the paper tension between
the tractors. Adjust the right
tractor so that it does not pull
paper too tightly or leave it too
loose. The right tractor should
hold the paper under slight
tension.
6. Inspect the ribbon mask for
bends or deformation that block
the paper path or prevent paper
from exiting the pedestal top
cover. Replace a damaged
hammer bank cover assembly.
7. Check the condition and tension
of the platen open belt. Adjust the
platen open belt. Replace the belt
if it is damaged.
Table 2. Message List
Message Explanation Solution
To Next Page
Loading...
