List Of Messages
67
PAP BAD TABLE*
Paper Bad Table. The paper
feed process on the
controller board has a
corrupted table.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with defective board.
PAP BSY TOO LNG*
Paper Busy Too Long.
Firmware error on the
controller board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again (page 150).
2. Run the print job again. If the
message appears, power off the
printer. Remove the paper path or
pedestal top cover. Make sure
connectors P106 and P107 are
fully seated on the controller
board. Make sure the MPU cable,
the hammer bank logic cable, and
the hammer bank power cable
are undamaged and have good
connections. Replace as
necessary. (Refer to Appendix
A.)
3. Power on the printer. Run the
print job again. If the message
appears, replace the shuttle
frame assembly.
4. Power on the printer. Run the
print job again. If the message
appears, replace the controller
board. Record the message and
return it with defective board.
PAP FD DRVR CIR*
See Manual
Paper Feed Driver Circuit.
The paper feed driver circuit
on the controller board is
drawing too much current.
1. Cycle power. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
2. Power on the printer. If the
message appears, replace the
paper feed motor.
Table 2. Message List
Message Explanation Solution
To Next Page
Loading...
