Printronix P5000 - Page 75

List Of Messages
75
QUEUE OVERRUN
In the CT twinax emulation,
the print buffer has
overflowed. Send a print job
to the printer.
1. If the message appears, replace
the expansion-CT board. Record
the message and return it with
defective board.
2. Send a print job to the printer. If
the message appears, replace
the twinax data cable and the
twinax auto-termination cable
assembly (“Smart T”).
RBN DRVR CIR*
See Manual
The ribbon driver circuit on
the controller board is
drawing too much current.
1. Cycle power. If the message
appears, replace the controller
board. Record the message and
return it with the defective board.
2. Power on the printer. If the
message appears, replace the
ribbon motors.
RESTORING
BOOT CODE
Normal download
initialization message.
No action required.
RIB INVLD CMD*
Ribbon Invalid Command.
Firmware error on the
controller board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with defective board.
RIB INVLD STATE*
Ribbon Invalid State.
Firmware error on the
controller board.
1. Cycle power. Run the print job
again. If the message appears,
download the emulation software
again.
2. Cycle power. Run the print job
again. If the message appears,
replace the controller board.
Record the message and return it
with defective board.
Table 2. Message List
Message Explanation Solution