Promise Technology Vess R3600 Series - Page 295

rc
Usage
rc [-a <action>] [-l <LdId>]
rc -a start -l <LdId> [-n] [-p]
rc -a stop -l <LdId>
rc -a pause -l <LdId>
rc -a resume -l <LdId>
Summary
The rc command is used to start and stop a Redundancy Check and monitor the progress of a running Redundancy
Check.
Options
-a <action> Species action to perform.
list (Default) Displays active and paused Redundancy Checks and their
status.
start Starts a Redundancy Check.
stop Stops a Redundancy Check.
pause Pauses a Redundancy Check.
resume Resumes a paused Redundancy Check.
-l <Pool ID> Species the Pool ID on which to run redundancy check.
-n Do not x inconsistent data. Specifying this option will cause redundancy
check to run without correcting inconsistent data. All inconsistency
errors found will still be reported.
-p Pause on error. This option causes Redundancy Check to pause when it
encounters inconsistent data. The default is to continue on error.
275
Promise Technology Managing with CLI