module Serial Number. To do this you follow the same restore procedure as previously shown except you
click the Restore by IP button instead of the Restore button
Backup and Restore Recommendations and Tips
Sometimes there are situations where just because a software application will allow you to do something
does not always mean that you should. The Backup and Restore functions in EasyRoll can fall into this
scenario. Even though you can technically create a backup file for a few or even a single module from within
a Subnet of many modules, it is not recommended that you do so. ConveyLinx support engineer’s
experience to date has indicated that when customers perform Backup and Restore functions for, at a
minimum, all modules in a Subnet, you will have fewer or no problems with your ConveyLinx networks.
Systems that were once working and then start producing unexpected results often stem from performing a
Restore function to a small portion of modules instead of the entire Subnet and/or starting with a backup file
that did not include all modules in the Subnet. So, here is a list of tips:
• When you perform a Backup; at a minimum, select all modules in a given Subnet
• When you perform a Restore; at a minimum, select all modules in a given Subnet
• Perform a new Backup after you make any settings changes to one or more modules in a Subnet
• Perform a new Backup after every time you perform an Auto Configure Procedure
Last modified: Aug 18, 2020
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 125 of 154
To Next Page
Loading...