R&S FPC Series - Page 268

Remote Control
R&S
®
FPC
265User Manual 1178.4130.02 ─ 07
Prerequisites for this command
●
Select an external trigger source (TRIGger[:SEQuence]:SOURce).
Parameters:
<TriggerSlope> POSitive | NEGative
*RST: POSitive
Example: //Select external trigger with a rising edge
TRIG:SOUR EXT
TRIG:SLOP NEG
Manual operation: See "Trigger" on page 372
See "Trigger" on page 394
TRIGger[:SEQuence]:SOURce
<TriggerSource>
This command selects the trigger source.
Parameters:
<TriggerSource> IMMediate
No trigger is applied.
EXTernal
Select an external trigger.
VIDeo
Select the video trigger.
The video trigger is only available if span = 0 ([SENSe:
]FREQuency:SPAN).
*RST: IMMediate
Example: //Select external trigger
TRIG:SOUR EXT
Manual operation: See "Trigger" on page 372
19.12.7 Traces
CALCulate<n>:MATH<t>:COPY:MEMory..........................................................................266
CALCulate<n>:MATH<t>[:EXPRession][:DEFine].............................................................. 266
CALCulate<n>:MATH<t>:STATe...................................................................................... 267
DISPlay<n>[:WINDow]:TRACe<t>:MEMory[:STATe].......................................................... 267
DISPlay<n>[:WINDow]:TRACe<t>:MODE.........................................................................267
DISPlay<n>[:WINDow]:TRACe<t>[:STATe]....................................................................... 268
FORMat[:DATA]............................................................................................................. 269
[SENSe:]DETector<t>[:FUNCtion]....................................................................................269
[SENSe:]DETector<t>[:FUNCtion]:AUTO.......................................................................... 270
[SENSe:]SWEep:COUNt.................................................................................................270
TRACe<n>[:DATA]?....................................................................................................... 270
Remote Commands of the Spectrum Application