R&S NRP2 - Page 211

Remote Control - Commands
R&S
®
NRP2
193User Manual 1173.9157.02 ─ 03
status reporting system which is described in detail in chapter 6.13, "STATus",
on page 292.
Commands available in the R&S NRP2
*CLS.............................................................................................................................193
*ESE.............................................................................................................................193
*ESR?...........................................................................................................................194
*IDN?............................................................................................................................194
*IST?............................................................................................................................194
*OPC............................................................................................................................194
*OPT?...........................................................................................................................195
*PRE............................................................................................................................195
*PSC............................................................................................................................195
*RCL.............................................................................................................................196
*RST.............................................................................................................................196
*SAV ............................................................................................................................202
*SRE............................................................................................................................202
*STB?...........................................................................................................................202
*TRG............................................................................................................................203
*TST?...........................................................................................................................203
*WAI.............................................................................................................................203
*CLS
CLear Status resets the
●
status byte (STB)
●
standard event register (ESR)
●
EVENt part of the QUEStionable and the OPERation register
●
Error / event queue
The command does not alter the ENABle and TRANsition parts of the registers.
Usage:
Event
*ESE <value>
Setting command: *ESE
Event Status Enable sets the event status enable register to the specified value.
Query: *ESE?
The query form *ESE? returns the contents of the event status enable register in decimal
form.
Parameters:
<Value> 0 to 255
Common Commands to IEEE 488.2