R&S NRP2 - Page 219

Remote Control - Commands
R&S
®
NRP2
201User Manual 1173.9157.02 ─ 03
Command Preset and *RST value Remark
SENS<[1]..4>:TIM:EXCL:STARt <NRf>
Depending on sensor.
SENS<[1]..4>:TIM:EXCL:STOP <NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER ON | OFF
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN <NR1>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO
OFF
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO:MTIMe
<NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO:RES
<NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO:POIN
<NR1>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO:NSR
<NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:COUN:
AUTO:TYPE
RES | NSR
Depending on sensor.
SENS<[1]..4>:TRAC:AVER:TCON MOV
REP
PRES and SYSTem:PRESet.
*RST.
SENS<[1]..4>:TRAC:OFFS:TIME <NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:POINt <NR1>
Depending on sensor.
SENS<[1]..4>:TRAC:TIME <NRf>
Depending on sensor.
SENS<[1]..4>:TRAC:REAL ON|OFF
Depending on sensor.
SERV<[1]..4>:SERR ON
Sample errors are signaled.
SYST:BEEP:NOT:KEY OFF
No key click.
SYST:BEEP:NOT:OVER OFF
No warning on sensor overload.
SYST:ERR:EXT OFF
No extended error message for
SYST:ERR?
SYST<[1]..4>:SPEed NORM
Depending on sensor.
SYST:STAN:PWS OFF
Window
SYST:STAN:TRIG:SOUR INT
Internal triggering.
TRIG:ALL:SYNC OFF
TRIG[1..4|:ALL]:ATR ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:COUN <NR1>
Depending on sensor.
TRIG[1..4|:ALL]:DELay <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:DEL:AUTO ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:DTIM <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:HOLD <NRf>
Depending on sensor.
Common Commands to IEEE 488.2