R&S NRP2 - Page 282

Remote Control - Commands
R&S
®
NRP2
264User Manual 1173.9157.02 ─ 03
Parameters:
<<resolution>> 1 | 2 | 3 | 4
Range: depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>]:AVERage:COUNt:AUTO:SLOT <slot>
Sets a timeslot whose measured value is used to automatically determine the filter length.
Parameters:
<slot> int_value
Range: depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>]:AVERage:COUNt:AUTO:NSRatio <nsratio>
Indicates the maximum noise ratio in the measurement result. Achieving the same result
by filter length setting is attempted only if
SENS<[1]..4>:AVER:COUN:AUTO ON and
SENS<[1]..4>:AVER:COUN:AUTO:TYPE NSR are set.
Unit: DB | PCT
Parameters:
<nsratio> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit: DB
[SENSe<[1]..4>]:AVERage:COUNt:AUTO:TYPE <mode>
Selects a method by which the automatic filter length switchover can operate:
Parameters:
<mode> RESolution
takes setting SENS<[1]..4>:AVER:COUN:AUTO:RES into
account.
NSR
takes setting SENS<[1]..4>:AVER:COUN:AUTO:NSR into
account.
*RST: depending on sensor
[SENSe<[1]..4>]:AVERage:RESet
Initializes the digital filter by deleting the stored measured values.
Usage:
Event
SENSe (Sensor Commands)