R&S NRP2 - Page 283

Remote Control - Commands
R&S
®
NRP2
265User Manual 1173.9157.02 ─ 03
[SENSe<[1]..4>]:AVERage[:STATe] <state>
Activates or deactivates the filter function of a sensor. If the filter is switched on, the
individual measured values set with SENSe<[1]..4>]:AVERage:COUNt are aver-
aged. This reduces the impact of noise and helps to achieve measured values that are
more stable.
Parameters:
<state> ON | OFF
*RST: depending on sensor
[
SENSe<[1]..4>]:AVERage:TCONtrol <mode>
As soon as a new single value is determined, the filter window is advanced by one value
so that the new value is taken into account by the filter and the oldest value is forgotten.
[SENSe<[1]..4>]:AVERage:TCONtrol (terminal control) then determines whether
a new result is calculated immediately after a new measured value is available
(MOVing) or only after an entire range of new values is available for the filter (REPeat).
Note:
In the MOVing mode, data from a point of time before the start of the current measurement
can influence the measurement result if the data is still in the filter.
Parameters:
<mode> MOVing | REPeat
*RST: REPeat; (PRES) and SYST:PRES: MOVing
[SENSe<[1]..4>]:BANDwidth:VIDeo <bandwidth>
[SENSe<[1]..4>]:BWIDth:VIDeo <bandwidth>
Sets the video bandwidth for the Trace mode.
Parameters:
<bandwidth> string
Range: "FULL", "5 MHz", "1.5 MHz", "300 kHz"
*RST: depending on sensor
[SENSe<[1]..4>]:BANDwidth:VIDeo:LIST?
[SENSe<[1]..4>]:BWIDth:VIDeo:LIST?
Provides a list of strings with permissible settings for
the[SENSe<[1]..4>]:BWIDth:VIDeo command. Lists are not affected by the *RST
command.
Usage:
Query only
SENSe (Sensor Commands)