R&S NRP2 - Page 293

Remote Control - Commands
R&S
®
NRP2
275User Manual 1173.9157.02 ─ 03
[SENSe<[1]..4>][:POWer]:TSLot:COUNt <number>
Sets the number of simultaneously measured timeslots in the Timeslot mode (see fig-
ure 6-13 Timeslot parameters).
Parameters:
<number> int_value
Range: depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>][:POWer]:TSLot[:EXCLude]:MID:OFFSet[:TIME] <time_interval>
Together with SENS:TSL:MID:TIME, allows a time interval in the timeslots to be blanked
out. SENS:TSL:MID:OFFS:TIME determines the distance from the start of the timeslots
to the start of the interval to be blanked out (see figure 6-13 Timeslot parameters).
Parameters:
<time_interval> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit: S
[SENSe<[1]..4>][:POWer]:TSLot[:EXCLude]:MID[:STATe] <state>
Activates or deactivates the blanking out of time intervals in the timeslots. There is no
direct command equivalent in the command groups of the power sensors. Instead, the
length of the interval is set to zero.
Parameters:
<state> ON | OFF
Range: depending on sensor
*RST: depending on sensor. If the *RST value of
SENS:TSL:MID:TIME is zero, the *RST value of
SENS:TSL:MID:STAT is OFF, otherwise it is ON.
[SENSe<[1]..4>][:POWer]:TSLot[:EXCLude]:MID:TIME <time_interval>
Together with SENS:TSL:MID:OFFS:TIME, allows a time interval in the timeslots to be
blanked out. SENS:TSL:MID:TIME determines the length of the interval to be blanked
out (see figure 6-13 Timeslot parameters).
Parameters:
<time_interval> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit: S
SENSe (Sensor Commands)