R&S NRP2 - Page 305

Remote Control - Commands
R&S
®
NRP2
287User Manual 1173.9157.02 ─ 03
[SENSe<[1]..4>]:TRACe:MEASurement:POWer:AVG?
Returns the measured average power in the current trace.
Usage: Query only
[SENSe<[1]..4>]:TRACe:MEASurement:POWer:MAX?
Returns the measured maximum power in the current trace.
Usage: Query only
[SENSe<[1]..4>]:TRACe:MEASurement:POWer:MIN?
Returns the measured minimum power in the current trace.
Usage:
Query only
[SENSe<[1]..4>]:TRACe:MEASurement:POWer:PULSe:BASE?
Returns the base power, computed in the pulse level analysis histogram of the current
trace data.
Usage:
Query only
[SENSe<[1]..4>]:TRACe:MEASurement:POWer:PULSe:TOP?
Returns the power of the first detected complete pulse of the current trace data, including
rising and falling edges.
Usage:
Query only
[SENSe<[1]..4>]:TRACe:MEASurement:PULSe:DCYCle?
Returns the duty cycle of the current trace data.
Usage:
Query only
[SENSe<[1]..4>]:TRACe:MEASurement:PULSe:DURation?
Returns the pulse duration (pulse width) of the first detected pulse in the current trace.
Usage:
Query only
[SENSe<[1]..4>]:TRACe:MEASurement:PULSe:PERiod?
Returns the time the pulse signal needs to complete one cycle.
Usage:
Query only
SENSe (Sensor Commands)