Raven OmniSeed Viper Pro - Page 154

Chapter 7
142 OmniSeed™ Viper Pro™ Installation & Operation Manual
Audible Alarm. When the audible alarm setting is enabled, the Viper Pro will sound a five second alarm tone if
an alert condition or alarm setting is detected on the CANbus (i.e. low tank or bin, zero speed, off rate percent
etc.).
The following alarms conditions may be enabled and will sound a tone if the audible alarm feature is enabled:
Note: Audible Alarms are enabled by default. Refer to the Feature Settings Area for Granular Products
section on page 144 for additional information about the above alarm settings.
Remote Master. Select the Remote Master option to use a proximity switch to toggle coverage mapping off or
on when the drill openers are raised and lowered during seeding operations.
Pause if Opener Raised. Enable this feature to automatically pause recording of field or zone feature
boundaries during a seeding operation when the drill openers are raised. This feature may be useful if the drill
will not be following the feature boundary, such as when turning and backing into corners or when refilling the
seed bins.
Boom Capacity. Enable the boom capacity feature on the Miscellaneous Settings screen to allow the field
computer to monitor the overall volume per minute for all products being applied.
To display the current boom capacity used during a field operation:
1. Touch the Display Data button on the main screen.
2. Touch within the Display Data prompt until the boom capacity information is displayed.
The current percentage of the entered maximum boom capacity is displayed. If the actual rate of application
reaches 90% or more of the maximum boom capacity, the Viper Pro will display the Boom Capacity Display
Data prompt to alert the operator to the application condition.
Maximum Capacity. Touch the maximum capacity value and use the key pad at the bottom of the
Miscellaneous Settings screen to enter the maximum boom capacity for the application equipment. Consult the
equipment documentation or contact a local equipment dealer or the equipment manufacturer for more
information on the maximum application capacity for the specific machine model.
• Dual Flow % (Percent) • Flow/Shaft Alarm
• Off Rate % (Percent) • Vacuum/Bin Alarm
• Low Tank • Zero Speed Shutoff
• Low Limit