Manual No. 016-3001-015 Rev. C 253
Advanced Section Setup
The standard boom setup covered in the Section Setup section on page 53 is sufficient for a standard boom
configuration with the sections end-to-end with no overlap or skips.
The advanced section settings allow the operator to customize boom or implement sections individually to
reflect specialized configurations with overlaps, skips or offset sections.
1. Select Menu, then Setup, and Boom.
2. Touch Next until the Boom Setup Summary screen is displayed.
3. Touch a boom section displayed in the section configuration overview or select the section summary entry
at the bottom of the screen to access additional section settings. The Boom Section Settings screen for the
selected section will display.
4. The Section Width for the section is displayed at the top of the screen. Touch the displayed value and use
the on-screen keypad to enter a new section width value if necessary.
5. Touch the Left/Right offset value and use the on-screen keypad to enter the distance of the section
midpoint from the GPS antenna. If the section is offset to the left of the GPS antenna, enter a negative
value for the Left/Right offset value.
Note: The left/right offset must be measured parallel to the boom or implement width. Select the More
Info button to display an overview of the offset measurements and directions.
To Next Page
Loading...
