4-4 Technical Data IndraControl L40
DOK-CONTRL-IC*L40*****-PR03-EN-P
The IndraControl L40 units are basically certified according to
• UL508 (Industrial Control Equipment) and
• C22.2 No. 142-M1987 (CSA)
However, it is possible that there are combinations or extension stages
with restricted or missing certification. Thus, verify the registration
according to the UL marking on the device.
Note: To guarantee an UL/CSA-compliant operation, you have to
fulfill the following conditions:
• Use 60/75 °C copper wire only.
4.5 Compatibility Test
All Rexroth controls and drives are developed and tested according to the
latest state-of-the-art.
As it is impossible to follow the continuing development of all materials
(e.g. lubricants in machine tools) which may interact with our controls and
drives, it cannot be completely ruled out that any reactions with the
materials used by Bosch Rexroth might occur.
For that reason, test new lubricants, cleaning agents, etc. for compatibility
with our housings / our housing materials before using the particular
material concerned.
UL/CSA Certification
Buy: www.ValinOnline.com | Phone: 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
Need help?
General
