Sending Scan File by E-mail
49
4
Note
❒ Press the item, and the soft
keyboard is displayed for en-
tering information appears.
Enter the first character or
characters of the item.
❒ One reference item of Ad-
vanced Search can be added
when [Search Options] is spec-
ified in [Program/ Change LDAP
Server] of [Key Operator Tools]
of System Settings. For more
information, see “User Tools
(System Settings)”, General
Settings Guide.
❒ It is necessary to differentiate
between capital and small
letters.
Reference
For information about how
to enter characters, see Gener-
al Settings Guide.
E Press [Search Criteria] corre-
sponding to each item and then
select criteria from the list to be
displayed.
Note
❒ You can select criteria from
the following list:
• [Search Beginning Word]:
The name located in front
of an entered character is
looked up.
• [Search End Word]: The
name located at the back
of an entered character is
looked up.
• [Exact Match]: The name
which corresponds to an
entered character is
looked up.
• [Include One of Words]: The
name which contains an
entered character is
looked up.
• [Exclude Words]: The name
which does not contain an
entered character is
looked up.
• [Fuzzy Search]: a vague ref-
erence (The function of the
vague reference depends
on the system supported
by the LDAP server.)
F Press [OK].
Note
❒ If a user name and password
for the LDAP authentication
are not set, a screen for enter-
ing a user name and pass-
word will appear. Enter
them to log on.
❒ A destination cannot be spec-
ified as a proper address
when the number of charac-
ters of the e-mail address
searched from the LDAP
server exceeds 128 charac-
ters.
❒ Some e-mail addresses can
be registered for one person,
but only one e-mail address
can be hit by searching. De-
pending on the system sup-
ported by the LDAP server,
generally, the address which
was registered for first is hit.
G Select a destination.
To Next Page
Loading...
