Ricoh Aficio 2022 - Page 828

Sending Scan File by Scan to Folder
62
5
Note
❒ To change the path for the
folder that has been entered,
press [Change] located on the
left side of the destination
field. Enter a path for the
folder properly, and then
press [OK].
❒ Pressing the {
{{
{Check Modes}
}}
}
key on the control panel lets
you check the list of selected
destinations.
❒ The connection test some-
times takes time.
❒ [Connection Test] can not be
pressed right after [Cancel]
was pressed during the con-
nection test.
❒ Though the connection test is
succeeded, the machine
sometimes fails in the file
transfer, when the shared
folder lacks writing authori-
ty or when there is no space
in the hard disk.
M To enter more destinations, re-
peat steps A
AA
A to L
LL
L.
Note
❒ To deselect a destination,
press [U
UU
U Prev.] or [T
TT
T Next] to
display the destination in the
destination field, and then
press the {
{{
{Clear/Stop}
}}
} key.
N Press [OK].
Specifying a folder in the FTP
server
A Press [Enter Destination].
B Press [FTP].
A confirmation message for
changing the protocol appears.
C Press [Yes].
D Press [Manual Input] on the right
side of the server name field.
The soft keyboard is displayed
for entering the server name.
E Enter a server name.
Note
❒
An IP address can be also entered.
F Press [OK].
G Press [Manual Input] on the right
side of the path field.
The soft keyboard is displayed
for entering the path for the
folder.
H Enter the path for the folder.
Note
❒ This is an example of enter-
ing a pass to send to the sub-
folder “lib” in the folder “us-
er”. user\lib
Reference
For information about how
to enter characters, see Gener-
al Settings Guide.