Ricoh Aficio 2022 - Page 829

Sending Scan File by Scan to Folder
63
5
I Press [OK].
J If entering a user name to log
on is required, press [Manual In-
put] on the right side of the user
name.
The soft keyboard is displayed
for entering the user name.
K Enter the user name.
L Press [OK].
M If entering a password to log
on is required, press [Manual In-
put] for password.
The soft keyboard is displayed
for entering a password.
N Enter a password.
O Press [OK].
P To change the port number
which is set in the initial scan
setting, press [Change] on the
right side of the Port No. field.
Enter a port number using the
number keys, and then press
[#].
Q Press [Connection Test].
A connection test is performed
to check whether the specified
folder exists.
Note
❒ To change a path for the fold-
er that has been entered,
press [Change] located on the
left side of the destination
field. Enter a path for the
folder properly, and then
press [OK].
❒ Pressing the {
{{
{Check Modes}
}}
}
key on the control panel lets
you check the list of selected
destinations.
❒ The connection test some-
times takes time.
❒ [Connection Test] can not be
pressed right after [Cancel]
was pressed during the con-
nection test.
R To enter more destinations, re-
peat steps A
AA
A to Q
QQ
Q.
Note
❒ To deselect a destination,
press [U
UU
U Prev.] or [T
TT
T Next] to
display the destination in the
destination field, and then
press the {
{{
{Clear/Stop}
}}
} key.
S Press [OK].
Searching to select a destination
folder from the network
A Press [Enter Destination].
B Press [SMB].
C Press [Browse Network] on the
right side of the path field.
The client computers list on the
same network appears.