Ricoh Aficio 2022 - Page 989

Remote Maintenance by telnet
101
9
ROUTE
Use the "route" command to control
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
Note
❒ The maximum number of routing
tables is 16.
*1
IP address
SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
❒ The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
SPRINT
Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 board is in-
stalled.
❖
❖❖
❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
msh> sprint
❖
❖❖
❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on |
off}|msh> sprint bidi {on
| off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is “on”.
Commands Topics of setting
route add
{host |
net}|route
add {host |
net} desti-
nation
*1
gateway
*1
Adds a host/network route
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
route de-
lete {host |
net}|route
delete {host
| net} desti-
nation
*1
Deletes a host/network route
from the table. Host becomes
the default.
route get
{destina-
tion
*1
}
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
route active
{host |
net}|route
active {host
| net} desti-
nation
*1
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
route add
default
gateway
*1
You can set the default gate-
way address.
route flush Deletes all routing informa-
tion.