Ricoh Aficio 2022 - Page 991

Remote Maintenance by telnet
103
9
Note
❒ When changing the interface to
IEEE 802.11b, see p.94 “TCP/IP
address”.
❒ When configuring the IEEE
802.11b TCP/IP, see p.94 “TCP/IP
address”.
Job Spool
Use the "spoolsw" command to con-
figure Job Spool settings.
Limitation
❒ You can only specify LPR, IPP, and
SMB protocol.
Note
❒ This information cannot reload au-
tomatically when you confirm Job
Spool settings with the Web
browser. Click [Reload] or [Refresh]
on the Web browser when you
want to reload this information.
❖
❖❖
❖ Reference
The Job Spool setting appears.
msh> spoolsw
❖
❖❖
❖ Job Spool setting
msh> spoolsw spool {on |
off}|msh> spoolsw spool
{on | off}
Note
❒ Select [on] to enable Job Spool or
[off] to disable it.
key [key value] 64-bit or 128-bit
can be set.
Only 10 hexadeci-
mal characters can
be set when using
64-bit; or 26 hexa-
decimal characters
when using 128-
bit.
Also, set 0x as the
prefix.
To use this func-
tion, set the same
WEP key for all
ports that transmit
to each other.
auth
[open|shared]
You can set the au-
thorized mode
when using WEP.
The specified val-
ue and the author-
ized mode are as
follows:
open: Open system
authorized (de-
fault)
shared: Shared key
authorized
rate [auto|11m|
5.5m|2m|1m]
You can set the
IEEE 802.11b trans-
mission speed.
The transmission
speed you specify
here is the speed at
which data is sent.
You can receive
data at any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps
fixed
5.5m: 5.5 Mbps
fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Parameter Value to be
configured