Ricoh Aficio 2022 - Page 992

Appendix
104
9
❖
❖❖
❖ Protocol configuration
To change protocol settings, use
the following command. You can
specify the setting for "lpr", "ipp"
or "smb".
• lpr
msh> spoolsw lpr {on |
off}|msh> spoolsw lpr
{on | off}
• ipp
msh> spoolsw ipp {on |
off}|msh> spoolsw ipp
{on | off}
• smb
msh> spoolsw smb {on |
off}|msh> spoolsw smb
{on | off}
Changing the host name
Use the "hostname" command to
change the printer name.
msh> hostname interface_name
printer_name
*1
If you did not enter the interface
name, it will be automatically set to
the Ethernet interface.
*2
Available when the optional 802.11b
interface kit is installed.
*3
Available when the optional 1394 in-
terface board is installed.
Note
❒ Enter the printer name using up to
15 characters.
❒ You cannot use a printer name
starting with "RNP" or "rnp".
❒ The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
WINS
Use the "wins" command to configure
WINS server settings.
❖
❖❖
❖ Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
msh> wins
WINS Configuration:
interface_name: WINS: On
primary server 0.0.0.0
secondary server 0.0.0.0
ScopeID
Current configuration:
primary server 0.0.0.0
secondary server 0.0.0.0
hostname host_name Sco-
peID
Note
❒ If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖
❖❖
❖ Configuration
Use the "set" command to make
WINS active or inactive.
msh> wins interface_name
{on | off}
•“on” means active; “off” means
inactive.
❖
❖❖
❖ Setting WINS Server Address
You can make settings for the
WINS server address.
msh> wins interface_name
{primary|secondary}|
IP_address
•“primary” is for setting the pri-
mary WINS server address.
•“secondary” is for setting the
secondary WINS server ad-
dress.
Interface name Interface to be config-
ured
ether
Ethernet interface
*1
wlan
*2
IEEE 802.11b interface
ip1394
*3
IEEE 1394 interface