Ricoh Aficio 2022 - Page 993

Remote Maintenance by telnet
105
9
❖
❖❖
❖ NBT scope ID setting
You can configure the NBT scope
ID.
Limitation
❒ Enter a scope ID using up to 31
alphanumeric characters.
msh> wins interface name
scope scope ID
Note
❒ If you receive different scope
IDs from DHCP and WINS, the
scope ID from DHCP takes pri-
ority.
*1
Available when the optional
802.11b interface kit is installed.
*2
Available when the optional 1394
interface board is installed.
AutoNet
Use the "autonet" command to config-
ure AutoNet settings.
❖
❖❖
❖ Display
The following command displays
the current AutoNet settings.
msh> autonet
❖
❖❖
❖ Configuration
You can configure the AutoNet
settings.
msh> autonet
interface_name
[on|off]|[on|off]
Note
❒ Select [on] to enable AutoNet.
❒ Select [off] to disable AutoNet.
❖
❖❖
❖ Interface Priority Configuration
You can assign priorities govern-
ing which interface obtains Au-
toNet parameters.
msh> autonet priority
interface_name
Note
❒ Priority assignment is useful
when connecting more than one
interface to the machine.
❒ If an interface is not selected, the
interface appears according to
the currently set priority, re-
gardless of multiple interface
connections.
*1
Available when the optional
802.11b interface kit is installed.
*2
Available when the optional 1394
interface board is installed.
Reference
For more information about
AutoNet, see p.110 “Using Au-
toNet”.
Interface
name
Interface to be config-
ured
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
ip1394
*2
IEEE 1394 interface
Interface
name
Interface to be config-
ured
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
ip1394
*2
IEEE 1394 interface