Ricoh J001 - Page 230

SM 8-30 J001/J003
(4) The ac power supply is not within range approved for
operation of the printer.
Power surge occurred. Power drop occurred. Check the rating of the input voltage.
(5) ST Descriptions
5-1 Operation impaired by other causes.
1 Harness disconnected, damaged.
2 Replace control board (NRC).
8.3.15 COVER OPEN/DUPLEX UNIT
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Cover open
A cover is open, the duplex unit is not set, or it is not set
correctly.
1 A printer cover is not closed.
2 Rear cover is not closed.
3 The duplex cover is open, or duplex unit is not installed
correctly.
4 Damaged.
(1) Check the printer covers to determine whether they have
been left open.
A printer cover is not closed. Close the printer covers.
(2) Check the rear cover to determine whether it has been left
open.
A printer cover is not closed. Close the rear printer cover.
(3) Make sure the following items are set correctly.
3-1 Duplex unit cover (J001)
3-2 Duplex unit (J003)
1 The duplex unit cover is not closed (J001).
2 The duplex unit cover is not set correctly (J003).
1 The duplex unit cover is not closed (J001).
2 The duplex unit is not set correctly (J003).
(4) ST Descriptions
4-1 Operation impaired by other causes.
1 Harness disconnected, damaged.
2 Interlock switch damaged.
8.3.16 PRINT HEAD CLEANING IN PROGRESS
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Print head is undergoing "Normal" or "Full" cleaning.
The print heads are being cleaning from the printer driver, the
print heads are being cleaned because the printer has been idle.
"Normal" or "Full" print head cleaning is in progress.
(1) After "Normal" or "Full" cleaning has finished, make sure the
printer goes online and is ready for normal operation.
"Normal" or "Full" print head cleaning is in progress. Wait for the printer to go online after the "Normal" or "Full"
cleaning has finished.
8.3.17 READY
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Printing...
A print job is in progress.
A print job is in progress.
(1) After the print job is finished, make sure the printer goes
online and is ready for normal operation.
Printing... Wait for the printer to enter the "Ready" mode after print job
is finished.
8.3.18 READY/RESET
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Print job reset.
The [Cancel] key has been pressed and the printer is erasing (a
Deleting print job data (resetting the printer).
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA