M126/M127/M128 4-70 SM
A flashlight may be required to remove the transfer roll.
1. Open the front access door.
2. At the right side of the transfer roll, squeeze the holder arms (A) with the left hand while lifting.
Stop when the holder is unlatched.
3. At the left side of the transfer roll, squeeze the holder arms with the right hand while lifting
with the left hand. Stop when the left holder is unlatched.
4. With a hand at each end, lift the transfer roll out.
Do not try removing the spring on the left; it is not removable but can be dislodged.
The spring included with the FRU is to be used only if the old right-side spring is
damaged or lost. Both springs must be positioned on posts that cannot be seen. If
the old springs are moved, then feel the base of the springs to assure that they are
on the posts. The top of the springs must be captured in the bearings of the transfer
roll.
To Next Page
Loading...
