Ricoh M126 - Clear Custom Status; Key Repeat Rate; Usb Speed; Wiper Message

M126/M127/M128 5-22 SM
5.2.30 KEY REPEAT RATE
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a
default of 15 times per second.
To change this setting:
1. Touch
to select "Key Repeat Initial Delay" from the Configuration Menu.
2. Touch
to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
Touch "Back" to cancel and return to the Configuration Menu.
5.2.31 WIPER MESSAGE
To change this setting:
1. Touch to select "Wiper Message" from the Configuration Menu.
2. Touch
or to change the value. The values are On (default) and Off.
3. Touch "Submit" to save the change.
Touch "Back" to cancel and return to the Configuration Menu.
5.2.32 CLEAR CUSTOM STATUS
No values exist for this operation. Pressing initiates this operation.
Touch
to select "Clear Custom Status" from the Configuration Menu.
 Executing this operation erases any strings that have been defined by the user for the
default or alternate custom messages.
5.2.33 USB SPEED
The USB Speed setting is used to set the throughput of the USB port on the machine. The
settings are Auto, whichis the default, and Full. Full forces the USB port to tun at full speed.