Ricoh M126 - Duplex Tests; Quick Test (Duplex)

Diagnostics Menu
SM 5-31 M126/M127/M128
System
Maintenance
Port Test Appears on the display
Port 2
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enabled
USB High Speed
Certification Testing...
Port 3
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enabled
USB High Speed
Certification Testing...
To stop testing before completion, turn the machine off.
5.3.5 DUPLEX TESTS
Quick test (duplex)
This test prints a duplex version of the Quick Test that can be used to verify that the correct
placement of the top margin on the back side of a duplex page. You can run one duplexed page
("Single"), or continue printing duplexed pages ("Continuous") until "Stop"
is pressed. For
information about changing the margin, see “Top Margin (duplex)” in “System Maintenance”.
 Before you set the duplex top margin, be sure to set the registration (
Registration
(Printer)).
The paper you choose to print the page on should be either Letter or A4.
To run the Quick Test (duplex):
1. Touch
to select "Quick Test" from DUPLEX TESTS.
2. Touch
to select "Single" or "Continuous".
 The single Duplex Quick test cannot be canceled.
 The machine attempts to print the Quick Test Page from the default paper source. If the
default paper source only supports envelopes, then the page is printed from Tray 1.
 Check the Quick Test Page for the correct offset between the placement of the first scan
line on the front and back side of a duplexed sheet.
The single test stops automatically when a single duplex sheet is printed, and the continuous test
continues until you press "Stop"
.