and
Adjustment
4.3.8 ADF CABLE REMOVAL
1. Left scanner cover ( p.4-85 "Left Scanner Cover Removal").
2. Left cover (
p.4-26 "Left Side Cover Removal").
3. Controller board shield (
p.4-10 "Controller Board Shield").
4. Lift the flatbed cover and unsnap the three tabs (A) securing the ADF rear cover to the ADF.
5. Rear ADF cover.
6. Disconnect the ADF cable (B) and two sensor connections (C) on the relay card above the
ADF relay cable.
7. Disconnect the ADF cable from connector J17 on the controller board.
8. Disconnect the ADF cable ground from the controller cage.
9. Take out the ADF cable.
To Next Page
Loading...
