Ricoh M126 - Adf Unit Removal; Imaging Component Removals

Imaging Component Removals
SM 4-73 M126/M127/M128
Replacement
and
Adjustment
4.3 IMAGING COMPONENT REMOVALS
4.3.1 ADF UNIT REMOVAL
1. ADF rear cover (release the three tabs (A) which fasten the ADF rear cover to the ADF unit).
2. Disconnect the ADF cable (B) and two sensor connections (C) on the relay card above the
ADF relay cable.
3. Lift the ADF unit up and depress the tabs located on the bottom of the ADF hinges to release
the ADF from the flatbed.