Ricoh M126 - Adf Feed Errors Service Check

M126/M127/M128 6-96 SM
6.5.27 ADF FEED ERRORS SERVICE CHECK
Step Questions / actions Yes No
1
If the ADF is multi-feeding, check for
dirt on the ADF separator pad and
ADF separator rollers. Are they
dirty?
Clean them with a
lint free cloth and
isopropyl alcohol.
Replace the
separator pad and
ADF pick roll.
2
If the paper is skewing when it is fed
into the ADF, check the paper guide
width. Is it set correctly?
Go to step 3.
Set the paper
guides so they
contact the edges
of the paper.
3
If paper is skewing when fed or
jamming check to see if the top
cover is open or ajar. Is the ADF top
cover open or ajar?
Properly close the
top cover.
If the paper is
jamming in the
ADF, See “ADF
Paper Jam Service
Check” in
“Troubleshooting”.
4 Is paper failing to feed into the ADF? Go to step 5. There is no issue.
5
Is the leading edge of the paper
wrinkled or torn?
Use different
media.
Go to step 6
6
Perform the ADF paper present
sensor test. See “Scanner Tests” in
“System Maintenance”.
Is the sensor working properly?
Go to step 7.
Properly connect
all the connections
in the ADF relay
card.
7
Check the actuators to see if they
are jammed, or damaged.
Are they jammed or damaged?
Replace the ADF.
See “ADF Unit
Removal” in
“Replacement and
Adjustment”.
Go to step 8.