Ricoh M126 - Page 243

M126/M127/M128 6-38 SM
Error Description Action
900.xx RIP software error
Turn off machine for 10 seconds and
restart. If error re-occurs, replace
controller board.
902.xx Engine software error
Replace the controller board ( p.6-50
"Controller Board Service Check").
903.xx Paperport link driver error
904.xx Interface violation by RIP
905.xx
Interface violation by paperport
device
906.xx RIP interface drive error
DC pick motor errors
910.xx DC pick motor stall
911.xx DC pick motor excessive PWM
912.xx DC pick motor below speed
913.xx DC pick motor over speed
914.00 DC pick motor error
914.01 Lost encoder feedback
Transfer service errors
917.xx Transfer service error
Replace the transfer roll (
p.6-85
"Transfer Roll Service Check").
Fuser service errors
920.00
Under temperature during steady
state control.
Replace the fuser ( p.6-58 "Fuser
Service Check").
921.00
Under temperature during standby
control.
922.00
Fuser failed to ramp to target
temperature