Ricoh M126 - Page 247

M126/M127/M128 6-42 SM
Error Description Action
959.21
Code did not respond to command
request.
“Controller Board Service Check” in
“Troubleshooting”.
959.22 Challenge secret failure
959.23 Self test failed during initialization.
Replace the controller board. See
“Controller Board Service Check” in
“Troubleshooting”.
959.24 EEPROM retention error
959.25
Insufficient device space during HW
prog
959.26
Incremental counter reset exceeds
maximum value
959.27
Increment count failed due to max
value limit
959.28 Invalid SP memory configuration
Memory and emulation errors
960.xx
RAM memory error: RAM soldered
on the controller board is bad
Replace the controller board. See
“Controller Board Service Check” in
“Troubleshooting”.
961.xx
RAM memory error: memory card in
slot is bad.
Replace the memory card.
964.xx
Download Emulation Cyclic
Redundancy Check Error: checksum
failure detected in the emulation
header or emulation file.
Disable the Download Emulation.
Program the download emulation into
the firmware card again. If this does
not resolve the problem, then replace
the firmware card and download the
emulation again.
Network errors
975.xx Unrecognizable network
Call the next level of support.
976.xx
Unrecoverable software error in
network port